Details of Kitchen Cabinet Measurements

  • Published:
  • Views:342
  • By:Swedish B2b

[Cabinet measurement details]

1. Measure the length twice, from left to right and from right to left, so as not to misread the size for the first time

2. When measuring the height of the suspended ceiling, measure several quasi-high points in different directions, and at the same time check whether there is a beam under the gusset plate.

3. When measuring, check the waistline, the height from the bottom of the motorized socket to the floor tiles, and the height of the window at the same time (more important when retesting, and pay attention when measuring).

4. When measuring, measure the distance and height of the gas meter and pipes from the wall, the height of the flue, the height of the water inlet and outlet, the drainage supervisor, the distance from the wall, the height of the socket (during retesting), etc.

5. When measuring, it depends on whether there are steps on the ground, whether there are concave-convex beams on the wall, and when making a hanging cabinet near the window, the pulling of the screen window should be considered. If it is related to the cabinet, the relevant size should be measured.

6. When retesting, the floor tiles should be laid and the wall tiles should be pasted. For example, when the wall cabinet or high cabinet reaches the top, the top must be hung before retesting.

7. When measuring special-shaped or polygonal shapes, it is necessary to select fixed points and measure diagonal lines. When making cabinets (ground and wall cabinets) on both sides against the wall, it is necessary to measure the distance between the inside and outside.

8. When there are poor bricks, measure the distance and height to the wall (including the height from the bottom and top to the ground). The normal refrigerator should be 700mm long, and the extra length should be added for special ones.

9. Measure the thickness of the door cover (including lines) where there is a door cover, or the floor and wall cabinet with a sliding door should allow the sliding door to be opened and a gap of 10-20mm should be left.

10. For example, when measuring the kitchen of the unit, pay attention to ask whether the wall is a stone plywood wall, so as to prevent the wall cabinet from being unable to be installed.

Send Inquiry